Installation of house heating heat pumps

House heating heat pump has become a new energy-saving and environmentally friendly product in recent years, but it has a big difference from the traditional definition of electric heating equipment. As the saying goes, three parts to the product, and seven parts to the installation. Especially for room heating heat pumps, installation is even more critical, because each key link can potentially affect the stable work of the entire device. Next, we will explain the installation of house heating heat pumps.

Here is the content list:

l Installation of house heating heat pump host

l Installation of room heating heat pump water tank

l Installation of power supply for room heating heat pumps

Installation of house heating heat pump host

1、If the house heating heat pump main unit is packed with a wooden frame, a pry bar and hammer should be used for disassembly and installation. When disassembling, be careful not to smash the main unit. If it is a carton package should be checked for deformation of the shell after disassembly.

2、The house heating heat pump unit should be installed in a location with good ventilation, and should not be installed indoors or in a place with poor ventilation. Generally, you can choose to install it on the balcony, roof, or outside the wall close to the end.

3、The closer the installation position of the room heating heat pump is to the water tank, the better it can reduce the heat loss of the pipeline. And the distance from other obstacles is not less than 1m.

4、If you need to build a protective shed for the room heating heat pump, the shed is not less than 1.5 meters away from the top of the room heating heat pump.

5、The installation position of the house heating heat pump should be chosen in the hardened over the place, and the bottom is fixed with expansion bolts.

6、The hand operator of the room heating heat pump should be installed in a convenient place for operation.

7、The base height of the house heating heat pump main unit should be more than 25~35cm above the ground to prevent snow cover and heavy rain flooding in winter.

Installation of room heating heat pump water tank

1、The water tank of the house heating heat pump should be installed in a place with a good load-bearing position. If it is used in commercial premises, it must be installed in the location of the main beam of the building or on top of the reinforced I-beam on the roof.

2、Room heating heat pump water tank should be placed in a flat position, horizontally without tilt.

3、The high and low water levels in the house heating heat pump tank should be placed in a reasonable position. A high water level probe should be placed about 25cm from the top of the tank to prevent water from overflowing.

4、The room heating heat pump tank must be equipped with a water softening system to prevent the piping system from scaling.

Installation of power supply for room heating heat pumps

1、The power line of the flooring heating heat pump should be configured with a ground wire and reliably grounded. Also, the circulating pump and booster pump of the room heating heat pump and other equipment need to be installed with the bottom wire.

2、Calculate the cable wire diameter according to the sum of the host and pump power of the house heating heat pump.

3、The power supply line of the room heating heat pump must be equipped with an all-pole disconnect earth leakage protector. The leakage protection current size is calculated according to P=UI and I=P/U. The resulting value multiplied by 1.5~2 is the rated current of the leakage protection.

If you want to get more information about the house heating heat pump, please consult us. Our website is www.inverter-heatpump.com.